There is something about wooden fences that can certainly catch anyone’s attention. Even neighbors can appreciate the beauty of wooden fences especially when they are in good condition. Most wood privacy fence can last around 10 to 15 years depending on the wood materials used. However, their lifespan may change depending on outdoor factors such as weather and others. For homeowners who recently moved to an old house, paying attention to it is recommended. Chances are that you will see some damages to the fence which means you need to know how to do minor repairs.
They are usually exposed to constant wear and tear including common decaying process. Just like it was mentioned a while ago, other factors may cause your gates to get damaged such as tree falling, strong winds, and even a car crashing onto it can really destroy it. When any of these events happen, you might need to replace the whole thing or simply replace the damaged sections. If you want to avoid having to spend money in hiring fence contractors, learning how to do simple repairs on your it should be done.
Tips on Repairing Wooden Fences
If your fence pickets are in need of repairs and you don’t want to hire a contractor to do the job, there are several steps that you can learn so that you will be able to fix any damages on your own. Here are some that you might want to keep in mind when it comes to keeping them in good condition.
- Get the right tools – If you want to fix your gates, you need to have the right tools first. Shovel, wheel barrow, hammer, tape measure and level are among those that you need to have or buy on hand before you start fixing the fences. It would be better if you ask for someone’s help like your kids or a friend of yours to help you with your repair project.
- Know which section to fix and the materials to use – You should know which section of the ones that you have should be repairing. Find out whether the boards are loose or that rot has set in. Normally, you will need around 80 lbs. of concrete bags for ever three posts. Nails and screws are needed also to secure the posts and boards in place.
- Remove panels that need to be replaced – The best way for you to remove the damaged panels is to peel it off from the posts using your hammer. After removing the panels, you can now proceed to removing the posts that have been damaged. If you don’t want to be digging up the concrete surrounding each post, simply cut the post that has been damaged then just offset it for about 4′.
- Measure the exact area where you will place the new posts – To make them sturdy, make sure that you have the exact measurements first. You should mark the first spot where you will place your posts and from there measure again for the second post and so on. Place the new posts after digging at least 2 to 3′ deep depending on the condition of the soil. You can now mix concrete which you need to pour down to the hole to secure your posts.
- Pour concrete – When you pour concrete onto the hole, make sure that you don’t fill it all the way to the top. You should leave around one to two inches before the top soil. You should repeat this process to all the new posts of your wooden fences. Let the cement dry before you begin adding the panels.
- Install replacement panels – The final stage to repairing your fences is to install the wood panels by placing the first panel on its proper place before securing it with nails or screws. It is better that you install the panels one at a time so yours will follow the flow of the land.
Wooden Fences – Finishing Your Gate Repair
If you want to make them appear uniform especially after looking at the fence that you have and the designs, after installing all the wood panels, you can simply level off their tops and you are done. Any gate repair that you may have in mind can be done without having to hire someone to do it for you. This way, when it comes to repairing your wooden fences, you will be able to save money while bringing back the natural beauty of your fences.