How to Work with a Glass Tile Installation

Glass tile installation is not often apt to use on high-use surfaces like floors and counter tops. Most designers tend to avoid using glass onesthat have been specifically produced for these areas since they tend to crack. However, there are ultra-glass tiles for sale that don’t crack and are specially made to be used as flooring tiles. It’s sometimes used as a back-splash and this can transform and give an ordinary looking kitchen a modern, chic look. But there are several problems that might be encountered with this installation. It can be very challenging to install because it contracts, unlike other tiles. Glass tiles also tend to be more expensive than tiles that are clay-based. So often times they are just used as decorative accents in bathrooms.


Glass Tile Installation Problems

One common problem encountered during the installation is how the residue under the tile is magnified because of the tile’s transparency. It is obviously transparent, but something as fine as a trowel ridge can be seen clearly. This sometimes gives an uneven finish and results being redone. To avoid this, dirt and dust should be cleaned from the back of it so it won’t be seen once it’s fitted. Backs of glass tiles that are 4” or more in size should be lightly buttered to stop the formation of air pockets. These air pockets are what usually lead to crack tiles. It’s crucial that it is fully bond to the cement to guarantee an even finish.

Another common, and some say most damaging, problem encountered during its installation is moisture. Once moisture seeps under it, mildew and molds can grow in a short amount of time. Homeowners can ensure this doesn’t happen by using grout that’s been cured properly for at least 28 days. But grout also needs moisture so it should be dampened continuously for 28 days after this.

A serious problem that can happen during or after it is cracking. Contractors encounter a lot of demands for backsplashes since it’s a very flexible tile. They expand and contract to adapt to the changes in temperature more than other materials that are for sale and because of this, they’re more prone to cracking. The larger pieces are even more inclined to cracking, so certain tile sizes were discontinued because they often crack during and after the installation.

Glass Tile Installation – How to Install Glass Tile the Easy Way

Tile distributors will inform you that there is not much difference between installation and buying ceramic tile.

Similar to using common concrete tile, this entails setting the it onto the surface. Mix the thin-set to a consistency of mash potatoes and set for 7-8 minutes. To maintain a clear translucent background, the thin-set used is commonly white so the glass’ color isn’t affected. Trowel the thin-set on the wall and spread it evenly so it lay smoothly. Press it into the thin-set lightly but firmly to ensure good contact.

Smaller sized tiles can be used during the process. Some of these are face mounted and has paper fastened with glue on the finished side. Smear some tile adhesive on the working surface, press lightly and let set. Make sure the papered side of the tile is facing out. Wet the side with paper thoroughly, leave for about 20 minutes for water to penetrate and then peel off the paper. Remove the remaining paper with a damp sponge and voila, you have an amazing floor tile patterns.

The next step to the installation would be adding grout. Mix, apply, and wash off grout and the job is almost done. Most contractors would recommend applying colored caulk around the tile’s perimeter. Remember that when a vertical and horizontal surface collides, there’s always movement. This often causes grout to crack and ooze out, so you should definitely put grout in these areas.

This can be easy, and as long as you follow these easy instructions, you can have the best flooring that will leave your friends green with envy.

Share This Post

Post Comment